2
II Safety
● Thank you very much for selecting Loncin generator, please carefully read and
understand this manual before operating the generator; safe operation procedures can
help you avoid accidents.
The procedures to ensure safe operation:
1. Each time before starting the generator, preoperation check must be performed (see
item 3 of Contents) to avoid accidents to the operators and damage to the
equipment.
2. Before starting the generator, good ventilation conditions must be ensured, and the
engine must be at least one meter from the building or any other equipment; never
put any inflammable object near the generator.
3. In order to avoid scald by the generator or hurt by moving parts, children and pets
must be kept away from the operation area.
4. Fueling must be performed in a place with good ventilation; before adding of fuel, the
engine must be stopped. Gasoline is highly inflammable and even explosive under
certain conditions.
5. When fueling is completed, ensure no residual gasoline exists on the surface of the
generator before restarting the generator.
6. In the places to fuel the generator and to store the fuel, no smoking, flame or spark is
allowed, or a fire or even explosion may be caused.
7. The exhaust gas of the generator contains carbon monoxide, so take care not to
inhale it. Never use the generator in an enclosed room or a place with inadequate
ventilation.
8. The generator shall be used on a stable ground surface on which the generator’s
inclination doesn’t exceed 20 degrees from the horizontal surface.
9. During the running of the generator, the muffler will be very hot and will remain hot
for a while after the generator is stooped. Never touch the muffler when it is hot, or
scald will be caused.
10. In order to avoid electric shock, never use the generator in a humid condition.
11. Never directly connect the generator to a home power supply.
III Preoperation check
1.Oil level of the engine
● If the engine runs without adequate engine oil in it, severe damage will be caused
to it.
● When checking the oil level of the engine, it must be stopped and put on a
horizontal ground surface.
To Next Page
Loading...
