C. Machine Operation
(1) Power On
a) Find the adapter and power cable and connect them. Please
Make sure to use DC 24V 5A and 7.5A adapters for 20W and
30W respectively.
b) Connect the power cord to the power supply and connect
the other end of the adapter to the power port of the
motherboard.
c) Connect the computer and the engraving machine through a
USB computer (or insert a Micro SD card).
d) Turn ON your LASER B1 by press the power switch (To Turn
OFF your LASER B1 by press the power switch once again.)
To Next Page
Loading...
