(3) We strongly recommend placing the machine in a well-ventilated
room, and at the same time, the door of the room has a sealing
effect, and the windows have curtains, to effectively avoid
looking directly at the laser beam and some smoke and steam ,
Particles, and other highly toxic substances. At the same time,
you can pay attention to the LONGER products (cover) in the
follow-up.
(4) The high-energy diode laser beam can produce extremely high
temperatures and significant amounts of heat as the substrate
material is burned away while engraving and cutting. Some
materials are prone to catch fire during cutting operations
creating flame, fumes, and smoke.
(5) Although the LASER B1 has a built-in flame sensor, this
technology should NOT be considered 100% accurate and should
be seen only as a warning system.
During the working process of LASER B1, if a flame is found, the
machine will stop the laser and make a sound to indicate
abnormal conditions. Please pay attention to the working status
of the machine.
during operation to ensure that any flare ups/ flame is properly
contained and extinguished.
It is strongly recommended that a Fire Extinguisher should be
To Next Page
Loading...
