located within proximity to the LASER B1. Extinguishers should
be halogen or multi-purpose dry chemical. Alternatively, or in
conjunction with the Fire Extinguisher it is recommended a “Fire
Extinguisher Ball” is positioned beside the LASER B1.
• DO NOT use materials that are highly flammable, explosive or
produce toxic by-products.
• DO NOT remove material from the cutting bed before it has
cooled.
• DO NOT leave the LASER B1 operating unattended.
• ALWAYS clean up clutter, debris, and flammable materials in the
laser LASER B1 bed after use.
• ALWAYS keep a properly maintained fire extinguisher nearby.
• DO NOT allow the USB cable to contact with the laser Beam.
• DO NOT allow the 24V power cable to contact with the laser
Beam.
(6) During the engraving process of the LASER B1 laser engraving
machine, different materials may produce different pungent
odors. Always use LASER B1 laser engravers in open and
well-ventilated areas.
(7) Environmental requirements
Temperature requirement: 10°C~30°C, humidity requirement:
20%~50%, this LASER B1 laser engravers can work normally
To Next Page
Loading...
