64
Adjusting the clasp Closing the clasp
Opening the clasp
1. Release the adjusting mechanism by
removing the pin from the hole in the
long section of the strap.
2. Slide the mechanism along this long
section and then x it by reinserting the
pin in the desired hole.
3. To open the clasp press in the push-
pieces on either side simultaneously.
4. Open the clasp to enlarge the bracelet
and remove the watch from your wrist.
5. Put the bracelet on your wrist and
slide the long section through the small
xed buckle.
6. Close the folding clasp until it clicks
into place. If necessary, slide the long
section through the small mobile buckle.
DEPLOYMENT BUCKLE
Book_I.indb 64 13.08.19 10:56
To Next Page
Loading...
Need help?
General