Before repair and maintenance, park the machine
on the level ground where there are no falling
stones or landslides. If parking is in a lower
position, there shall be no danger of flood, and
then shut down the engine.
After stopping the engine, shift the joystick of the
working device to the position of up and down in
order to release the left pressure within the
hydraulic oil circuit. Then lower the working
device to the ground, and lock up the joystick with
locking kit.
Pull up the parking brake switch, perform braking
and put wedge down the tire.
Lock up the front and rear frame with frame fixing
rod. During maintenance, be careful not to be
touched or to be hooked by moving parts.
When the lifted bucket is inspected and
maintained, be sure to fasten the working device
support to prevent the working device from falling,
shift the joystick to the “neutral” position and then
lock up the joystick with locking device.
To Next Page
Loading...
Need help?
General
