4D-Nucleofector
®
Next Generation
Quick Guide
Installation of units
1. Unpack the units
2. Connect the cables as shown
3. Switch on the device at the rear
4. Press the power button at the front
The core unit will automatically detect the functional units attached.
Starting an experiment
1. Pick the vessel type you will use in your experiment by tapping on
the vessel symbol (A)
2. Select the wells to dene by tapping on the well or dragging across
the screen for denition of more than one sample at once
3. Press “Next” to see a summary of all dened wells (this step is
only enabled if all selected samples are fully dened (Sample Type,
Pulse Code and Solution))
4. Load the sample in the Nucleocuvette® Vessel
5. Press “Start” to run the experiment (C)
A
B
C
Prior to rst use please read the manual provided with the USB stick or at www.lonza.com/new-4d-nucleofector and
read the safety instructions carefully.
• Pick sample type (B)
• Choose pulse code and solution or pick a
predened cell type code
• Press “Deselect” to remove the selection
To Next Page
General
