Q1: I can’t connect the APP.
A: (1) Please check if you’ve turned on the WIFI? Is the blue light flashing?
Please stop recording and press twice to turn on the WIFI, then you can find
WIFI. (2) Please check if you connect WIFI, not Bluetooth. (3) Please check the
flashing of the lights, if you see 3 lights flashing very quick means the camera
can’t detect the memory card, you need to press 5 times to format the card then
you can turn on the WIFI and connect it.
07
1. Download the LOOKING CAM APP.
2. When the camera is turned on, short press the key button twice to turn
on the WIFI. When the WIFI is on, the blue WIFI indicator light will flash, but
if it is not connected to the phone within 1 minute, WIFI will automatically turn
off. If the connection with the mobile phone is successful, the blue WIFI
indicator light will remain on.
3. Go to your phone's general setting page to find the device WIFI and enter
the password to connect it. The default WIFI name is DB1+SSID****, default
password is 12345678.
PS. Please don’t change the WIFI name nor the password to avoid any
connection error.
4. When the device is connected to the phone successfully, you may open
the APP to view it. By using the APP you can start/stop recording, take
photos and playback…etc.
5. When connected to the WiFi, all operation (such as start / stop recording)
should be done through the APP because the key button on the device will
be disabled.
6. You can make any general setting from the setting page, the setting icon
is on the top right corner.
PS. The camera will stop recording when you're in the setting page.
Once done setting, don't forget to go back to the main page to continue
recording.
Common Questions
To Next Page
Loading...