To Next PageTo Next PageHow to stop smoke from entering the room during Lopi Wood stove start-up?
If smoke enters the room during start-up of your Lopi Wood stove, it may be due to a cold air blockage. To address this, burn a piece of newspaper to establish a draft. Also, ensure the air control is fully open. If more air is needed, slightly crack the door.
What to do if kindling does not start in my Lopi Answer Wood stove?
If the kindling in your Lopi Wood stove isn't starting and the fire is smoldering, there might be a cold air blockage; try burning a piece of newspaper to establish a draft. Also, ensure you're using enough starter paper; add more newspaper if needed. Check that the air control is fully open, and if additional air is required, slightly crack the door.
Why is the blower not running on my Lopi Answer?
If the blower on your Lopi Wood stove isn't running, it could be because the stove hasn't reached the required temperature yet; the blower usually activates after 15 to 30 minutes. Another reason could be an interruption in the electricity supply to the blower. Check the household breaker or fuse to ensure it's working.
What to do if smoke enters the room while reloading a Lopi Wood stove?
If smoke enters the room while reloading your Lopi Wood stove, first stabilize the air by pushing the air control in before opening the door. Open the door approximately 1 inch, allowing air to enter the firebox for a few seconds. Once the smoke consistently flows up the chimney, fully open the door. If the issue persists, it may be due to insufficient draft. Adding more pipe or a draft-inducing cap may help.
Why does my Lopi Answer not burn hot enough?
If your Lopi Wood stove isn't burning hot enough, several factors could be at play. The wood might be wet. Ensure the air control is fully open by sliding it back and forth to prevent it from sticking. Insufficient draft may also be the cause; adding more pipe or a draft-inducing cap could help.
General| Maximum Log Size | 18 Inches |
|---|---|
| Flue Size | 6 Inches |
| EPA Certified | Yes |
| Blower Included | Optional |
| Emissions | 2.5 g/h |
| Construction | Steel |
Welcome and overview of the manual's purpose.
Details on model, serial number, and warranty card guidance.
Key safety warnings including door closure, airflow, fuel type, and hot surfaces.
Adherence to installation instructions and contacting local officials.
Maintaining safe distances from flammable materials around the appliance.
Available configurations for installing the wood stove.
Performance metrics like heating capacity and burn time.
Physical measurements and clearances for the stove.
Environmental compliance details for the appliance.
Guidance on planning the stove installation process.
Specifies non-combustible floor protection requirements and dimensions.
Details safe placement and minimum clearances to combustibles.
Guidelines for chimney connector, type, and installation.
Special requirements for installing the stove in an alcove.
Specific safety and installation rules for mobile homes.
Illustrations for various factory-built and masonry chimney installations.
Guidance on planning the insert installation process.
Specifications for fireplace opening dimensions for insert compatibility.
Mandatory hearth extension specifications for safety and code compliance.
Specific requirements for installing inserts in masonry fireplaces.
Specific requirements for Z.C. metal fireplaces.
Procedure for creating and installing a block-off plate.
Steps to verify installation and prepare for initial operation.
Step-by-step guide for safely starting a fire in the stove.
How to control the fire intensity using the air control.
Procedure for safely removing ashes from the firebox.
Common problems and solutions for appliance operation.
Routine checks and cleaning tasks for daily operation.
Tasks for regular inspection and upkeep of the appliance.
Annual checks and servicing for optimal performance.
Identification of components that make up the appliance door.
Identification of internal firebox components.
Details on parts and labor coverage by year.
Terms and limitations of the warranty agreement.
Procedure for obtaining warranty service and claims.
Certification and compliance information for the appliance.
Key installation requirements for various configurations.
Instructions for attaching stove legs.
Guide for installing the optional pedestal base.
Steps for installing the rear-mounted blower.
Procedure for installing the outside air intake boot.
Instructions for fitting and installing surround panels.
Steps for installing the front-mounted blower.
