To Next PageTo Next PageHow to stop smoke from entering room during Lopi Endeavor start-up?
If smoke enters the room during the start-up of your Lopi Wood stove, open the air control. If there is a cold air blockage, burn a piece of newspaper to establish a draft. If the flame isn't getting enough air, even a small crack in the door might be all that's needed.
What to do if smoke enters the room while reloading Lopi Wood stove?
If smoke enters the room while reloading your Lopi Wood stove, try these steps: First, open the bypass. Next, open the air control before opening the door. Allow the air to stabilize before fully opening the door; initially, open it about 1 inch to let air into the firebox for a few seconds. Once the smoke consistently flows up the chimney, open the door fully. Also, ensure there is sufficient draft; adding more piping or a draft-inducing cap may help.
Why does smoke enter the room when I reload my Lopi Indoor Fireplace?
Smoke may enter the room while reloading your Lopi Indoor Fireplace because of insufficient draft. To address this, consider adding more pipe or a draft-inducing cap. Before opening the door, open the bypass and air control. Allow the air to stabilize before fully opening the door. Initially, open the door about 1 inch (26mm) to let air into the firebox for a few seconds. Once the smoke consistently flows up the chimney, you can fully open the door.
How to stop smoke from entering the room during Lopi Indoor Fireplace start-up?
To prevent smoke from entering the room during the start-up of your Lopi Indoor Fireplace, try the following: Open the bypass and the air control. If there's a cold air blockage, burn a piece of newspaper to establish a draft. If the flame isn't getting enough air, even a small crack in the door might be enough.
Why doesn't my Lopi Indoor Fireplace burn hot enough?
Your Lopi Indoor Fireplace might not burn hot enough if the wood is wet. Ensure you are using properly seasoned wood. Also, check that the air control is fully open and not stuck. Insufficient draft can also cause this issue; adding more pipe or a draft-inducing cap may help.
General| Brand | Lopi |
|---|---|
| Model | Endeavor |
| Category | Wood stove |
| Language | English |
