41
4. Insert the pump cap and screw it on as
far as it will go.
$"%
The handle on the pump cap must be
in a vertical position.
5. Insert the maintenance ap and lock it
into place.
6. Close the maintenance ap.
Before the next washing
To prevent unused detergent from
draining during the next wash, run the
Drain program after emptying the
pump.
1. Open the water supply.
2. Plug in the mains plug.
3. Switch on the appliance.
4. Pour 1 liter of tap water the
compartment II.
5. Run the Drain program.
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is not
being pumped out, you must clean these.
1. Switch o the appliance.
2. Disconnect the appliance’s mains plug
from the power supply.
3. Loosen the hose clamp and carefully
remove the water outlet hose.
Residual water may leak out.
4. Clean the water outlet hose and siphon
connecting piece.
To Next Page
Loading...
Need help?
General
