IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to make sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packaging straps before you start to assemble.
• Do not tighten all screws/bolts until pieces are completely assembled.
• Keep all hardware parts out of children's reach.
• It is recommended for 2 persons to complete this assembly.
Assembly Instructions
Top Panel 59605/16202/16200/16201/59607/16199/34405/16198
Side Leg Frame-Full Length 16204/16205
Adjustable Cross Bar Set 16208
Side Leg Frame-Short Length 16206/16207
High Table Side Leg Frame 16209
STEP 7
STEP 9
STEP 8
STEP 10
If the other leg does’nt align the edge of
the top panel,usually need one man make
this leg at the correct position,another man
tighten 6 pcs screw “C”.
Rubber hammer
TWO PEOPLE ARE REQUIRED TO
ASSEMBLE AND MOVE THIS MODEL
Only assemble one side leg using 6 pcs
screw “C”.
Suggest to keep the
distance of 5mm from metal
edge to panel edge.
Suggest to keep the
distance of 5mm from metal
edge to panel edge.
To Next Page
Loading...
Need help?
General
