Lorentz PSk2 Series - Re-Assemble the Touch Protection

Page 10 / 13
BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
Version: V150818
8
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
4.4. Re-assemble the touch protection
a) Push the touch protection in the
upper left corner of the controller
housing.
b) Put the touch protection under the
touch protection with the terminal
clamps.
c) Make sure that the three (3)
abutment screws are in correct
position.
d) Reassemble the two (2) fixing screws
with the PH2 screwdriver.