BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
4.2. Remove the Current board
a) Disconnect the ribbon cable
connector from the current board.
b) Use the PH1 screwdriver to remove
the two (2) plastic screws of the
current board.
You need the 5,5mm wrench to
hold the nut on the other side of
the cupper bar.
c) Now you can remove the current
board.
To Next Page
Loading...