BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
g) Pull the touch protection slightly up
and push it to the left side.
h) Now you can remove the touch
protection.
i) Now you can localize the current
board on the left side.
Don’t bend the touch protection
including the terminal clamps
more than 90° in order to not
damaging any other parts.
To Next Page
Loading...