BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
e) Use the PH2 screwdriver to remove
the screw in the bottom right corner
of the housing.
Please note that there is a
locking nut on the back side of
the controller which must be
hold with the 8mm wrench.
f) Use the PH2 screwdriver to remove
the two (2) fixing screws.
To Next Page
Loading...