BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
4.3. Assemble the new Current board
a) Bring the new current board in
correct position (the arrow has to
show to the left side and the ribbon
cable plug must be at the bottom).
b) Assemble the two (2) fixing screws
with the locking nuts. Take care not to
overtighten the plastic screws!
c) Reconnect the ribbon cable connector
to the current board.
To Next Page
Loading...