BERNT LORENTZ GmbH & Co. KG
Siebenstücken 24, 24558 Henstedt-Ulzburg, Germany,
Tel (+49) 0 4193 8806-700, Fax -708, www.lorentz.de
Guide for replacing the Current Board (v2 and v3) in a PSk2 series pump
controller (PS7k-2, PS9k-2, PS15k-2)
All specifications and information are given with good intent, errors are possible and products may be subject to change without notice.
Pictures may differ from actual products depending on local market requirements and regulations.
Make sure that the ribbon
cable connector is in correct
position to assemble it with the
LEDcontrol board.
g) Reassemble the touch protection.
h) Reassemble the three (3) fixation
nuts with the 8mm wrench.
To Next Page
Loading...