Thread the cord from the inside
through the hole in the shaft side
and pull the knot into the hollow of
the shaft side.
Thread the other end of the cord
from the outside through the hole
in the other shaft side and make a
knot at that end too. Pull the knot
into the hollow.
Installing the shafts and the cords that connect them to the toggles
Turn the loom upside down, so
that it rests on the back beam and
the top of the castle.
This picture shows the 40 cm
Jane, which has a carrying
handle.
The 70 cm Jane does not have such a handle because it is too wide to
comfortably carry the loom in that way. The 70 cm Jane can best be carried
by turning it 90 degrees and hold it using the cross bar of the castle.
To Next Page