Louet Jane - Troubleshooting; The shed is too small; The handles are hard to lift; The shaft cords come from the rollers

14
Troubleshooting
The shed is too small
Possible cause:
• The fabric has to be advanced.
The handles are hard to lift
Possible causes:
• The tension of the warp is too high.
• The fabric needs to be advanced.
• You left the lease sticks in the warp between the shafts and the back
beam.
The shaft cords come from the rollers
Possible causes:
• You adjusted the shafts too low, so they rest on the elastic cord or on a
roller underneath, resulting in the shaft cords becoming slack.
• The fabric has to be advanced:
When you lift shafts a part of the warp will go up. This will lift the fabric,
which will lift the part of the warp and shafts that should stay down a
bit, as well. When you weave the fabric close to the shafts, this
upwards pull becomes stronger and then the elastic cords cannot keep
the shafts down and the cords of that shafts become slack.
• You left the lease sticks in the warp between the shafts and the back
beam.