6
Replace the top side pieces one by one:
Remove the two screws that hold the front rail.
Unscrew the socket-head nut and remove the
side piece. If the threaded end remained in the
barrel nut, take it out and take the barrel nut out
too.
Insert the barrel nut into the new top side piece
and assemble it in the reversed sequence, the
barrel nut facing the inside.
Screwing the side piece to the front rail it is
important to find the thread that is cut in the
hole the first time: Lift the front rail and find its
hole with the tip of the screw. Now turn the
screw anti clock wise while giving some
pressure. You will feel and hear when the screw
falls in the original thread and you can screw it
in, which should easily.
Repeat the procedure at the other side of the
loom. Slip the shelf bottom into the slot of the
front rail (you may need to loosen the screws at
the side pieces one turn).
Slip the shelf bottom into the slot of the front
rail. You may need to loosen the screws at the
side parts one turn.
Fasten the shelf front to the top side pieces,
using two of the 50 mm screws.
To Next Page
Loading...
