To Next PageTo Next Page
Need help?Do you have a question about the Louet Spring and is the answer not in the manual?
General| Type | Floor Loom |
|---|---|
| Mechanism | Parallel countermarch |
| Shafts | 8 |
| Material | Beech |
| Optional | Second warp beam, sectional warp beam |
| Weaving Width | 90 cm (35.4 inches) |
| Treadles | 10 |
Explains the traditional countermarch system with diagrams for understanding loom operation.
Highlights five key advantages of the parallel countermarch system over traditional ones.
Details the function of the moving breast beam in controlling warp tension and shed formation.
Describes Texsolv cord and heddles, their properties, and handling instructions.
Provides guidance on using barrel nuts and carriage bolts for loom assembly.
Details the importance of sequence for washers/spacers and proper wood screw usage.
Lists the metric tools needed for assembling the loom, including specific wrench sizes.
Instructions for mounting the base and middle side pieces onto the main middle part of the loom.
Guides on replacing top side pieces and inserting the shelf bottom during assembly.
Details how to attach warp beam supports to the back beam using screws.
Instructions for preparing treadles by screwing small screws and assembling them onto the foot rail.
Covers attaching floating arms, springs, and cords to hold the moving breast beam.
Instructions for installing the cloth beam lever, ratchet, and connecting beam cords.
Guides on connecting the lower reed holder, inserting the locking pin, and turning beater hinges.
Instructions for aligning the beater, adjusting its height, and correcting unevenness with cardboard strips.
Covers installing the brake disc, lever, spring, and cable for the warp beam.
Explains how to tie upper and lower lams to treadles according to weaving drafts.
Details how to check and adjust the height of shaft bars and lams for correct loom operation.
Provides steps for adding or removing heddles from the shaft bars.
Discusses cross sticks, the raddle, and general threading guidelines for the warp.
Explains how to adjust warp tension using spring cords and the floating arms.
Guides on setting the correct beater height for optimal shedding and yarn protection.
Instructions on how to fold the back section of the loom for easier transport.
Lists key points for checking loom levels, cords, and fasteners for proper functioning.
Identifies common problems like poor sheds, stuck treadles, and slanted cloth with potential causes.
