Louisiana Grills LG900 User Manual (English)

Questions and Answers:

H
Hannah JohnsonAug 18, 2025
Why does my Louisiana Grills LG900 Grill have frequent flare-ups?
- S
  shieldsrhondaAug 18, 2025
  Frequent flare-ups in your Louisiana Grills Grill can occur due to several reasons: * **Cooking Temperature:** High cooking temperatures, especially when cooking greasy foods, can cause flare-ups. Try cooking at a lower temperature, ideally below 176°C / 350°F. * **Grease Build-Up:** Accumulated grease can ignite and cause flare-ups. Follow the recommended Care and Maintenance instructions to prevent grease build-up. * **Flame Broiler Is Open:** An open flame broiler can lead to flare-ups during indirect flame cooking. Close the flame broiler to prevent this.
H
hayden83Aug 23, 2025
What to do if my Louisiana Grills Grill produces excess or discolored smoke?
- W
  williamslisaAug 23, 2025
  Excessive or discolored smoke from your Louisiana Grills Grill may be due to: * **Grease Build-Up:** Follow Care and Maintenance instructions to address grease accumulation. * **Wood Pellet Quality:** Replace moist wood pellets with dry ones and clean out the hopper. * **Burn Grate Is Blocked:** Clear the burn grate of any moist wood pellets and follow the Hopper Priming Procedure. * **Insufficient Air Intake For Fan:** Ensure the fan is working correctly and that its air intake isn't blocked. Clean the fan if it's dirty.
M
Matthew NicholsAug 26, 2025
Why Louisiana Grills Grill shows "Er-1" Error Code?
- B
  bmartinezAug 26, 2025
  The “Er-1” error code on your Louisiana Grills Grill indicates: * **Overheating:** The unit may have overheated due to a grease fire or excess fuel. Turn off the grill, let it cool, and follow the Care and Maintenance instructions. Ensure all component parts are correctly positioned. * **Grill Probe Connection:** The grill probe may not be making a proper connection. Check the probe for damage and ensure it's clean. Also, check the connection to the Digital Control Center by disconnecting and reconnecting the silver and brown wires.
M
Michael HarveyAug 28, 2025
What to do if my Louisiana Grills LG900 Grill has no power lights on the digital control center?
- M
  Mark StricklandAug 28, 2025
  If there are no power lights on the digital control center of your Louisiana Grills Grill: * **Power Button:** Press the Power Button, holding it for two seconds to ensure a solid connection. * **Not Connected To Power Source:** Verify the unit is plugged into a working power source and reset the breaker. Ensure the GFCI is a minimum 10 Amp service, and all wire connections are firmly connected and dry. * **Fuse Blown On The Control Board:** Check the fuse for a broken or blackened wire and replace it if necessary. * **The Gfci Outlet Has Been Tripped:** Ensure all wire connections are firmly connected and dry. Ensure GFCI is a minimum 10 Amp service. * **Faulty Control Center:** The Digital Control Center may need replacement. Contact Customer Service.
M
Misty SimmonsAug 30, 2025
Why Louisiana Grills Grill shows "Er-2" Error Code?
- S
  Shawn FullerAug 30, 2025
  The “Er-2” error code on your Louisiana Grills Grill suggests that the grill failed to perform the start-up cycle. To resolve this: * Follow the Set-up Procedure instructions. * Check the hopper for sufficient fuel and ensure there are no obstructions in the feed system. Remove pellets and follow Care and Maintenance instructions. * Check the grill probe to confirm the ACTUAL temperature is correct and accurate. Clean the probe if dirty. * Check the igniter positioning and ensure it is heating up properly. * In extremely cold conditions, a second start may be needed. Turn the grill off, wait, and then turn it on again. * Check the fan to ensure it is working properly. Clean it if dirty.
S
Scott LeachSep 2, 2025
What to do if the fire in burn grate of my Louisiana Grills LG900 Grill will not light?
- T
  tammy56Sep 2, 2025
  If the fire in the burn grate of your Louisiana Grills Grill won't light: * **Burn Grate:** Check the burn grate for proper positioning and follow Care and Maintenance instructions for ash build-up. * **Auger Motor Is Jammed:** Inspect the auger feed system to ensure the auger is dropping pellets into the burn grate. If not, contact Customer Service. * **Igniter Not Working Properly:** Check the igniter by feeling for heat above the burn grate and confirming its alignment with the hole in the burn grate. If it's not working, follow the Manual Start-up Procedure and contact Customer Service. * **Igniter Failure:** The igniter may need to be replaced. Contact Customer Service.
D
David EwingSep 4, 2025
Why Louisiana Grills LG900 shows "Er-3" Error Code?
- H
  harrispaigeSep 4, 2025
  The “Er-3” error code on your Louisiana Grills Grill indicates a power interruption during operation. This means the grill did not complete its cool-down cycle. Check your power supply to ensure there wasn't a power outage. To resolve this, turn the unit off, wait two minutes, and then turn it on again. If the error persists, contact Customer Service.
C
Christopher NguyenSep 7, 2025
What to do if the LED display has wrong readout on my Louisiana Grills LG900 Grill?
- S
  sarah35Sep 7, 2025
  If the LED display on your Louisiana Grills Grill shows the wrong readout: * **Temperature Setting Switch:** Disconnect the unit from the power source. Access the back of the Digital Control Center by removing the hopper access panel. Locate the temperature setting switch and flip it to either ºC (Celsius) or ºF (Fahrenheit), as preferred. Then, replace the hopper access panel.
A
Austin ChaseSep 9, 2025
Why is the fan turning on by itself in my Louisiana Grills LG900?
- I
  ian81Sep 9, 2025
  If the fan in your Louisiana Grills Grill is turning on by itself, it's likely because the interior temperature of the grill has reached or exceeded 54°C / 130°F. This is a self-cooling feature and doesn't harm the unit. To reduce the inside temperature, open the grill lid or unplug the unit and move it to a shaded area.
D
darrenromeroSep 12, 2025
Why readout of ACTUAL temperature will not adjust on my Louisiana Grills Grill?
- B
  Brandi YoungSep 12, 2025
  If the ACTUAL temperature readout isn't adjusting on your Louisiana Grills Grill: * **Grill Probe Dirty:** Follow the Care and Maintenance instructions to clean the grill probe. * **Grill Probe Wire Is Wet:** Use a hair dryer to dry the grill probe wires. * **Grill Probe Is Broken:** The grill probe may need to be replaced. Contact Customer Service.