Safety Precautions
Proper application of battery
1. As the gas overflowed from batte
ry may run the risk of
explosion, the battery shall be far away from open flame
(such as matchsticks, lighters or cigarettes etc.); avoid short
circuit, sparks.
2. The battery is only used for starting engine, not for any other
purpose.
3. When the battery is charged or replaced, you should read the
caution labels on the battery carefully.
4. Remove bond strap on negative pole (-
), then remove the
battery. To install battery, the first step is to install the
positive pole (+) cable.
5. Before the battery is charged, remove it from machine.
6. Prior to charging, check if battery end cap vent is smooth and
the ambient is ventilated.
7. Proper charging current depends on rated capacity of battery.
After the charging is over, disconnect power supply, and
detach cable from battery post to prevent battery explosion
caused by possible electric ignition.
8.
Do not use the batteries out of those specified for the
machine.
9. It is more dangerous to touch with electrolyte (dilute Sulfuric
acid). If it touches with eyes, skin and clothes, immediately
wash them away with clean water; If it is splashed into eyes,
flush it fully with clean water, then seek medical treatment.
To avoid injuries, the following actions shall be taken:
① Wear goggles and rubber gloves;
②
Avoid breathing smoke generated by respiratory
electrolyte;
③ Prevent electrolyte splash or drip;
④ Use correct and parallel startup process.
Fig. 1-11 Application of battery
Fig. 1-12 Electrolyte danger
Fig. 1-13 Check of battery
Keep roll bar installation correct
If the roll bar becomes slack or is removed for any reason, it is required to reinstall the remaining parts in a right
way. Tighten set bolts to right torque. If the roll bar structure is damaged, such as rollover accident, distortion etc.,
protective function may be lessened. The damaged roll bar must be replaced with a new one.
– pole Start
5
To Next Page
Loading...
