Lovol TE254 - Maintenance During Period of Sealing-Up for Safekeeping Tractor; Unseal Tractor

Storage
6.2.12 The tractor shall be parked in a hangar or car shed with ventilated and dry air. Prohibit to be put them with
corrosive substances and gas together. If the conditions are not met, you must cho
ose the dry platform in
higher ground for storage when parking in open places, and to cover it with tarpaulin.
6.2.13
Clean up all the parts and provided tools removed from the tractor and wrap them up carefully, then store
them in a warehouse with dry air.
6.3 Maintenance during period of sealing-up for safekeeping tractor
6.3.1 During sealing-up period for safekeeping tractor, all the above requirements must be met.
6.3.2 Check once every a month to see if the tractor and parts appear corrosion, agin
g and distortion, etc., if any,
take actions for troubleshooting immediately.
6.3.3
Rotate engine crankshaft for 10~15 turns every 2 months to prevent internal parts from corrosion. Remove the
old lubricating grease where the parts need to refilled and put new lubricating grease.
6.3.4 Start tractor to drive for 20-30 minutes once every 3 months, and check all the parts for exception functions at
idle speed.
6.3.5 Use a dry cloth wipe up the top surface of battery regularly,. The battery will be self-discharged, even during
unused period. It shall be recharged once every month.
Important:
If the user doesn’t have the conditions for antirust disposal, and the tractor needs to be shutdown for
several months or more, replace oil, oil filter at least, and
start it once every 2 months, then check all parts for
abnormal functions when driving 20-
30 min at idle speed. While keep the surface of tractor clean, dry to prevent
machine parts from damage due to corrosion.
6.4 Unseal tractor
6.4.1 Remove the grease used for antirust.
6.4.2 Unclose all pipe ends and clean tractor.
6.4.3 Fill with coolant, oil, diesel and each lubricating point with the grease according to specifications.
6.4.4 Clear antirust agent in fan pulley slot and install pulley belt. Adju
st drive belt tension according to technical
specification (see the user manual for engine operation and maintenance).
6.4.5 Install battery, and apply Vaseline on connecting terminal.
6.4.6 Check tightness of all circuits, pipelines.
6.4.7 Operate tractor as required in the manual.
Note: More information for sealing-up and unseal engine, see “Operation and Maintenance Manual for the Engine”.
71