What to do if my Lowenstein Medical Equipment device does not reach the set target pressure?
If your Lowenstein Medical Equipment device isn't reaching the set target pressure, there are a couple of things you can check: * The air filter might be dirty. Try cleaning it, and if that doesn't work, replace it. * The breathing mask may be leaking. Adjust the headgear to ensure a tight fit. If the mask is still leaking, you might need to replace it.
What to do if my Lowenstein Medical Equipment shows error (601), (610) or (609)?
If your Lowenstein Medical Equipment displays error codes (601), (610), or (609), it indicates a faulty SD card. Try removing the SD card and reinserting it. If the message persists, replace the SD card.
What to do if my Lowenstein Medical Equipment shows error (204)?
If your Lowenstein Medical Equipment shows error (204), this indicates that the humidifier is not working properly. Remove the humidifier from the device and then reconnect it. If the message continues to appear, contact an authorized specialist dealer to have both the device and humidifier checked.
What to do if my Lowenstein Medical Equipment shows error (701)?
If your Lowenstein Medical Equipment shows error (701), this indicates a leak on the humidifier or at the cover on the side. Remove the humidifier or side cover from the device and reconnect it. If the message continues to be displayed, contact an authorized specialist dealer to have the device and the humidifier checked.
What to do if my Lowenstein Medical Equipment shows error (603)?
If your Lowenstein Medical Equipment displays error (603), it means the SD card is full. You should delete data from the SD card or use a new SD card.
What to do if my Lowenstein Medical Equipment displays other error codes?
If your Lowenstein Medical Equipment displays error codes other than those specified, it may indicate electronics problems. Disconnect the device from the power supply and then reconnect it. If the message continues to be displayed, contact an authorized specialist dealer to have the device and the humidifier checked.
Why Lowenstein Medical Equipment therapy cannot be started by taking a breath?
If therapy on your Lowenstein Medical Equipment cannot be started by taking a breath and the device doesn't switch off after removing the mask, it could be due to these reasons: * The autoSTART function is not activated. You should activate it. * The autoSTART function may be restricted when using accessories with high resistance. Contact your specialist dealer.
How to fix Lowenstein Medical Equipment when there is no running noise and nothing in the display?
If your Lowenstein Medical Equipment shows no running noise and nothing appears on the display, it's likely due to no power supply. Check that the power cord is securely connected and verify the function of the socket.
Why softSTART cannot be switched on in Lowenstein Medical Equipment?
The softSTART function on your Lowenstein Medical Equipment might be disabled. Ask your physician whether the function can be enabled.
General| Device Type | CPAP Device |
|---|---|
| Category | Medical Equipment |
| Therapy Modes | CPAP, APAP |
| Ramp Function | Yes |
| Humidifier | Integrated Heated Humidifier |
| Data Storage | SD Card |
| Display | LCD |
| Connectivity | Bluetooth, USB |
| Ramp Time | 5-45 minutes |
| Weight | 1.4 kg |
| Power Supply | 100 – 240 V AC, 50/60 Hz |
To Next Page
