COASTER/PAGER PROGRAMMING
The T95XXLCM will program the pagers and coasters.
1. Set the Mode for the type of pager/coaster being programmed
• 9 1 6 Prog for Guest
• 9 1 7 Prog for Star Pager (staff pagers).
2. Select the System ID (0, 1, 2, or 3).
3. Set Vibrator On/Off (Coaster Call Only)
• 9 2 0 Prog to set the Vibrator Motor On.
• 9 1 9 Prog to set the coaster to be silent when paged.
4. Remove the Coaster/Pager to be programmed from the charger.
5. When the pager/coaster stops flashing, press the pager number to program fol-
lowed by Prog
6. After the pager/coaster responds by glowing and fading away, page the unit with
message 1 to be sure it programmed as desired and set aside.
7. Repeat steps 4 – 6 for the remaining units to be programmed.
Long Range Systems 7 T9550 LCM User Manual
To Next Page
Loading...
