iS7 220V Auxiliary Power Option Card User Manual
- For details, see cable standard below.
<Cable Standard>
① Cable Standard : AWG20~12
② Recommended Cable Standard
Recommended Wire Size
[mm2] (AWG)
③ Recommended Wire Size Crimp Terminal
④ Cautions
- When you arrange control wiring by using a cable tie to work, you should
work in a place more than 15cm away from the inverter.(Otherwise, top
cover of drive may not be assembled)
- The standard of wire must be at least more than 300V and higher than 75℃
With copper wires
- When tightening the terminal block, the width of screwdriver’ tip is less than
2.5mm and the thickness of screwdriver is less than 0.4mm in use.
To Next Page
Loading...
