CAUTION:
Never park loader without bucket attached
to the loader.
CAUTION:
Never allow weight of tractor to be put on
parking leg when removing loader.
▶ Park the tractor and loader on hard level surface.
▶ Raise the boom until the bucket is about 2 feet
off the ground.
▶ Remove the Pin and R-pin from „K‟.
Open the Stand „X‟ by the Bracket „Y‟.
Assembly the Pin and R-pin at the „L‟
▶ Lower the boom until the Parking legs make
contact on the ground.
Tip the bucket until the bucket cutting edge touch
the ground.
▶ Remove the latch pin while move the control lever
back and forth slightly to make the latch pin easy.
▶ Pull the control lever to raise the loader until the
post lift off mounting frame.
Adjust the bucket until the bottom surface of bucket
touch the ground.
▶ Move the tractor backward slowly and stop to
avoid the hydraulic hoses being tighten.
▶ Stop the engine and move the control lever back
and forth, left and right several times to reduce the
hydraulic pressure in the hoses.
▶ Disconnect the quick couplers on the hydraulic
hoses.
To Next Page
Loading...
