INSTUM_01378 Pag. 4/12
2 Product installation
2.1 General safety rules
Please read the following general safety rules in order to avoid injuries to people and prevent
damages to the product or to possible other products connected with it. In order to avoid any
damages, use this product exclusively according to the instructions herein contained.
The installation and maintenance procedures must be carried-out only by authorized and skilled
service personnel.
Power the instrument in a suitable manner. Pay attention and observe the power supplies like
indicated for the model in your possession.
Carry-out all connections in a suitable manner. Pay strict attention to the connection diagrams
supplied with the instrument.
Do not use the product in case of suspected malfunctions. In case of suspected malfunction, do not
power the instrument and contact authorized technical support immediately.
Do not set working the product in an explosive atmosphere.
Before you carry-out any operation on electrical connections, power supply system, sensors and
communication apparatus:
Disconnect the power supply.
Discharge the accumulated electrostatic discharges touching an earthed conductor or
apparatus.
2.2 How to choose the survey site
Select a site with conditions representative of the environment being examined. Thermo-
hygrometers must be assembled in sites where the morphological conditions of the earth, the urban
structures and the environmental conditions in general make them particularly representative of the
general conditions in which the measurement is to be performed.
It is important that there are no structures in the nearby areas which might radiate heat, such as
cement floors, asphalt, walls, etc. The thermo-hygrometers should be installed at 1.5 - 2 m from the
To Next Page
Loading...
Need help?
General