Need help?Do you have a question about the LSI MegaRAID SAS 9361-4i and is the answer not in the manual?
General| PCI Express slots version | 3.0 |
|---|---|
| Internal SATA ports quantity | 4 |
| Supported storage drive interfaces | SAS, Serial ATA |
| Quantity | 1 |
| PCI Card form factor | Full-height (low-profile) |
| PCI Express connector | Yes |
| RAID levels | 0, 1, 5, 6, 10, 50, 60 |
| Certification | EN55022, EN55024, EN60950, EN 61000-3-2, EN 61000-3-3; FCC Class A, Class B; UL1950; UL; CSA C22.2; VCCI; RRL f/ MIC; BSMI; C-tick |
| Internal memory | 1024 MB |
| Data transfer rate | 12 Gbit/s |
| Memory clock speed | 1866 MHz |
| Internal memory type | DDR3 |
| Mean time between failures (MTBF) | 1343187 h |
| Logical block addressing (LBA) support | 64 bit |
| Voltage | 12 V |
| Operating temperature (T-T) | 0 - 55 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
Weight and Dimensions| Depth | 167.6 mm |
|---|---|
| Width | 64 mm |
Instructions for unpacking and inspecting the RAID controller before installation.
Steps to prepare the host computer, including powering down and removing the cover.
Guide on inserting the RAID controller into a PCIe slot and securing it.
Steps for configuring and installing SAS or SATA devices in the host computer.
Instructions for connecting the RAID controller to SAS/SATA devices using cables.
Procedure for powering on the host computer and connected storage devices.
Steps to launch and use the BIOS configuration utility for setting up groups.
Guide for installing the necessary software drivers for the RAID controller.
To Next Page
