Connect the device follow the instructions: The
indicator changes from flashing status to the off state,
then can be matched. Please reboot the power supply,
once the blue light is not flashing.
After confirming that the WiFi-RDM01 has already
matched with the RDM device, follow the instructions to
connect the wifi through the phone. The factor y default
WiFi name is WiFi-RDM01, no password.
After finishing setting, click " " in the upper right corner
will pop-up the Search and Add button; Search means to
search device again, Add means to add device.
The edit can be proceeded after the device searching
succeeded.
A, Press the appropriate box of ADDR, then the address
can be edited.
B, Press the UID code, the information of this device will
pop up.
C, Press DIM button “ “ and then enter the Dimming
interface.
Back to the device inter face, press the button on the
top left corner, enter setting interface.
Press D IM Ra ng e, then t he paramete rs of th e
dimmable driver can be set. If the driver of our company
was among the searched devices, then appropriate
model parameters will show the editable status, current
value, and dimming range.
Slip dimming rod left and right to adjust the dimming.
1.Connected & Matched 2.Connected WiFi 3.Search & Add Device 4.Edit
5.Dim
6.Edit the power supply setup
iOS / Android
Scan QR code to download the APP via mobile phone
7.Modify WiFi password
Back to setting interface, modify the WiFi SSID no. and
password by clicking the WiFi setting.
Scan QR code to follow our website
www.ltech-led.com
To Next Page
Loading...
Need help?
General
