User Manual of Network Camera
77
Task 3 Set the Alarm Actions Taken for Motion Detection in Section 6.6.1.
Figure 6-49 Exception Settings
3. Click Save to save the settings.
6.6.6 Configuring Line Crossing Detection
This function can be used for detecting people, vehicles and objects crossing a
pre-defined area. The line crossing direction can be set as bidirectional, from left to
right or from right to left. And a series of linkage method will be triggered if any
object is detected.
Steps:
1. Check the Enable Line Crossing Detection checkbox.
2. Click the Draw Area, and a crossing plane will show on the image.
3. Click on the line, and you will see two red squares on each end, drag one of
the red squares to define the arming area.
Figure 6-50 Draw Crossing Line
To Next Page
Loading...
