3
the product. A protective ground connection, by way of the grounding
conductor in the power cord, is essential for safe operation. Do not
defeat the safety purpose of the grounding plug. The grounding plug
has two blades and a third grounding prong. The third prong is provided
for your safety. When the provided plug does not fit your outlet, consult
an electrician for replacement of the obsolete outlet.
Danger from If the protective ground connection is lost, all accessible conductive
Loss of Ground parts, including knobs and controls that may appear to be insulated,
can render an electric shock.
Proper Power Cord Use only the power cord and connector specified for the product and
your operating locale. Use only a cord that is in good condition. Protect
the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
Proper Fuse The user accessible fuse is a part of the IEC AC inlet connector. The
fuseholder accepts 5 x 20mm diameter fuses.
For 117VAC operation, the correct value is 1/2A, 250VAC, slow
blowing (Bussman type GDC-500MA).
For 230VAC operation, the correct value is 1/4A, 250VAC, slow blowing
(Bussman type GDC-250MA).
Operating Location Do not operate this equipment under any of the following conditions:
explosive atmospheres, in wet locations, in inclement weather, improper
or unknown AC mains voltage, or if improperly fused. Do not install
near any heat source such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat. Unplug this apparatus
during lightning storms or when unused for long periods of time.
Stay Out of the Box To avoid personal injury (or worse), do not remove the product covers or
panels. Do not operate the product without the covers and panels
properly installed. Only use accessories specified by the manufacturer.
Clean only with a damp cloth.
User-serviceable parts There are no user serviceable parts inside the ADA8824. In case of
failure, refer all servicing to the factory. Servicing is required when the
ADA8824 has been damaged in any way, such as when a power supply
cord or plug is damaged, liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
To Next Page
Loading...