Hose Attachment
Lucid drone technologies has selected the Banjo Polypropylene Cam & Groove fitting to attach a pump hose to
the drone. The fitting is mounted below the drone and plumb to the ground. The fitting offers a 3/4 “ coupling
size, made to support a ½” hose.
C1 users may need to purchase a male counterpart to utilize this fitting/connector in order to attach it to a ½”
hose.
Prior to takeoff, ensure your hose is properly attached to the aircraft. Failure to do so may
cause an in-flight emergency.
Prior to takeoff, ensure the sprayer nozzle is properly attached to the aircraft. Failure to do so
may cause the nozzle to act as a projectile and cause damage to nearby subjects.
GPS Antennas
The C1 drone comes with two (2) detachable GPS
antennas used to provide heading and direction to the
aircraft. The two (2) antennas look like small black
cylinders that can be found in your remote case. Prior
to each flight, install the two antennas on the top of the
aircraft. Antennas are affixed to the drone via small ¼”
screws. Screw the antennas onto the drone, hand
tighten only, DO NOT OVER TIGHTEN THE
ANTENNAS.
The antennas must be affixed to the aircraft prior to
each flight. Take the antennas off of the aircraft after
each flight for transportation of the aircraft.
To Next Page