Lucid C1 - Page 45

50 Flight Hours
1. Deep Batteries
2. Frame Checkup
a. Check upper and lower plates for cracks and damage
b. If Cracks exist, call lucid for further support
3. Check frame Arm locks for wear
4. Check frame arms to ensure still tight and not loose
5. Turn on aircraft and check for abnormal noise
6. Check Payload plate, or isolate plate, tighten screws if necessary
7. Check cables, don't move them aggressively
8. Tighten any screws that seem loose
9. Apply threadlocker to any screws that may need it.
10. Check motor bases for cracks or damage
11. Ensure arms lock in place at correct altitude
12. Check Landing Gear Screws, tighten if necessary
13. Spin Motors and Propellers to ensure they spin freely
14. Check remote controller, check for damage
15. Check remote controller antennas for damage
16. Spray motors with keyboard duster to ensure the motors are free of debris.
100 Flight Hours
1. Deep Batteries
2. Frame Checkup
a. Check upper and lower plates for cracks and damage
b. If Cracks exist, call lucid for further support
3. Check frame Arm locks for wear
4. Check frame arms to ensure still tight and not loose
5. Turn on aircraft and check for abnormal noise
6. Check Payload plate, or isolate plate, tighten screws if necessary
7. Check cables, don't move them aggressively
8. Tighten any screws that seem loose
9. Apply threadlocker to any screws that may need it.
10. Check motor bases for cracks or damage
11. Ensure arms lock in place at correct altitude
12. Check Landing Gear Screws, tighten if necessary
13. Spin Motors and Propellers to ensure they spin freely
14. Check remote controller, check for damage
15. Check remote controller antennas for damage
16. Spray motors with keyboard duster to ensure the motors are free of debris.
17. TAKE PROPS OFF OF THE MOTORS
18. TURN ON THE DRONE, START MOTORS TO CHECK MOTOR SPIN AND FREE OF DEBRIS.
19. Listen to the motors for abnormal sounds.
20. REPLACE THE PROPELLERS, DO NOT INSTALL OLD PROPS.
21. Check battery cables for abrasions.
22. Update the drone firmware if necessary.
C1 Operations Manual 45