C1 Cleaning Drone Components and Specifications
C1 Drone Specifications
The C1 cleaning drone is a large hexacopter with multiple sensor failsafes. It was built to carry hose lines to
perform cleaning operations. Due to the specific nature of this drone, the operational protocols may differ from
other drones and subsequent operations.
Please note that while these specifications are accurate, the data was aggregated from the drone flying in
pristine flight conditions.
The specifications of this drone are malleable due to the operating conditions. Specific operating conditions
will change the operating specifications of the aircraft.
Environmental Conditions that could change operating expectations from the C1:
1. Wind
a. (higher winds will decrease flight times)
2. Elevation:
a. (higher elevation will decrease flight times)
3. Temperature
a. (Temperature extremes will affect flight times)
4. Humidity and Dew Point
a. (Humidity could change density altitude and affect aircraft performance.)
5. Payload
a. Heavier payloads will decrease aircraft performance
b. Lighter payloads will increase aircraft performance
6. Batteries
a. Improper battery care can decrease aircraft performance
Drone Specifications
(Data aggregated from low winds, moderate temperature and low altitude)
C1 Weight (At Takeo without hose attached): 27lbs
Flight Time 12-20minutes
Aircraft Diameter 53”
Aircraft Height 24”
Operating Altitude: Limited to 115’
Operating Radius: Limited to 200’
Batteries Dual (2x) 6s 16000mah LiPo
To Next Page
Loading...