6b Using the Printer Interface window, raise the hot end temperature up to 240°C by typing 240
under “Temperature”, then clicking Set in the Printer Interface window. Monitor the current printer
temperature using the status bar at the top of the Printer Interface window.
Printer Interface
Temperature Control
Temperature Status
Your LulzBot Mini is tested for quality assurance before being packaged. You will need to remove the
remaining filament left in the tool head from this process before loading new filament for your next
print. 240°C is the required hot end temperature to remove HIPS from the tool head. See Step 14 for the
required temperature for other materials.
i