Need help?Do you have a question about the LulzBot TAZ 5 and is the answer not in the manual?
General| Filament Diameter | 3mm |
|---|---|
| Nozzle Diameter | 0.5mm |
| Print Speed | Up to 200 mm/s |
| Print Technology | Fused Filament Fabrication (FFF) |
| Connectivity | USB, SD Card |
| Software | Cura LulzBot Edition |
| Operating System Compatibility | Windows, macOS, Linux |
| Supported Materials | PLA, ABS, HIPS, PVA, PETG, Nylon |
| Print Surface | Heated borosilicate glass |
| Bed Leveling | Automatic |
| Power Requirements | 100-240VAC, 50/60Hz, 5A |
To Next Page
