LulzBot TAZ 5 - Plugins; Outer Shell Speed; Inner Shell Speed

3D Printer Software
compared to your inner and outer shells, you can have adhesion issues or
globs of lament left behind from the print head.
Outer Shell Speed
This will be the outermost surface of the model. This is the most important
speed setting, as it controls the speed of your print head on the visible layers.
As a general rule of thumb, the slower you go the better looking print you
will get.
Inner Shell Speed
This aects vertical walls that are in between the outer shell and inll. This
will not be visible but will help support the outer shell and the inll. We
recommend keeping this speed setting between your inll and your outer
shell speed.
Minimal Layer Time
This will determine a minimum amount of time your printer will spend
laying down each layer. If your layer print time falls below this your printer
will automatically slow down to reach this time before moving onto the next
layer. Tweaking this can help get cleaner, crisper prints.
Enable Cooling Fan
Enables operation of your extruder active cooling fan. The fan settings can
be adjusted in the Expert Settings options.
1.12 Plugins
Plugins are custom settings which will alter your print at specic
points. The two that come preloaded with Cura are Tweak at Z, and
Pause at Height. More plugins and information can be found here:
http://wiki.ultimaker.com/Category:CuraPlugin To activate one of
these highlight the desired plugin and click the drop-down arrow directly
below the Plugins box.
36