Ready to keep going?: https://www.LulzBot.com/next
Share ideas & collaborate:
Forum.LulzBot.com
Start Here
unpacking your
TAZ 3D printer
Save all packing materials,
packing clips, inserts,
documents, and the box in case
you need to ship your printer or
contact customer support.
Note:
1
Remove the Accessory Tray foam insert from the
box, set aside.
2
Slide out the tool bag and foam padding from the
left side of the printer frame.
Carefully remove printer frame from box and set it on a
sturdy, flat surface - you're ready for assembly!
next up:
Setting up your printer
A
Remove the printer bed assembly (Y-axis)
packed in the body of the printer by sliding it up
6", freeing it from the packing foam.
While keeping the printer in the box, pick up by
the black aluminum frame and rotate the printer
and foam 90 degrees - setting it upwright within
the box. Make sure name plate at top is UP. Remove top
foam.
4
B
Rotate printing bed assembly, tilting the bottom
toward front of box. Lower entire bed into box so it is
parallel with printer frame, then lift out and set aside.
3
To Next Page
Need help?
General
