LulzBot TAZ 5 GUIDE
--PRE-SETUP--
1. Ensure print bed and nozzle are clean. The print bed should be smooth across the
surface.
2. Ensure the filament reel has enough filament for your print. Make sure the filament is
not tangled on itself, and that none of it is broken leading from the reel to the extruder
nozzle. Make sure the reel is able to spin freely on the handle.
3. Close any windows around the printer, so the temperature around the machine will not
fluctuate. Fluctuating temperatures may cause the filament to gunk up inside the
extruder as well as warp your print.
--Machine—
Section 1: The switch is the power-switch while the port is a USB type B. Using a USB type A
To Next Page
