LulzBot TAZ 5 - Expert Mode Speed Options

2.5. EXPERT MODE
speed is a safe starting point, and it is not unrealistic to attain speeds
of up to 250mm/s (if your printer can handle it). Adjusting the speed of
perimeters, inll is available in simple mode, and the general rule is to have
the perimeter go a little slower than the inll in order to reduce possible
blemishes on the surface (inll can be faster because slight gaps will not
matter as much).
Expert mode oers more parameters to ne tune printer speeds. Dif-
ferentiation between external, small and other perimeters, inll locations,
and bridges and gaps are available, as well as the ability to slow down for
the rst layer.
Figure 2.21: Expert mode speed options.
89