LulzBot TAZ 5 - Hazards and Warnings

WARNING!
Read Me First!
READ THIS MANUAL COMPLETELY BEFORE UNPACKING AND
POWERING UP YOUR PRINTER.
Hazards and Warnings
Your LulzBot
®
TAZ 3D printer has motorized and heated parts. Always
be aware of possible hazards when the printer is operational.
Electric Shock Hazard
Never open the electronics case when the printer is powered on. Before
removing the electronics case cover always power down the printer and
completely turn o and unplug the power supply. Allow the power supply
to discharge for at least one minute.
Burn Hazard
Never touch the extruder nozzle or heater block without rst turning o
the hot end and allowing it to completely cool down. The hot end can take
up to 20 minutes to completely cool. Never touch recently extruded plastic.
The plastic can stick to your skin and cause burns. The heated bed can
reach high temperatures that are capable of causing burns.
Fire Hazard
Never place ammable materials or liquids on or near the printer when
it is powered on or operational. Liquid acetone and vapors are extremely
ammable.
Pinch Hazard
When the printer is operational take care to never put your ngers in
any moving parts including belts, pulleys, or gears. Tie back long hair or
clothing that can get caught in the moving parts of the printer.
x