LulzBot TAZ 5 - Installing Drivers; Cura

1.3. INSTALLING DRIVERS
the 3D model. We recommend that new users start with Cura as it
includes the printer host as well.
Recommended Slicers:
• Cura
• Slic3r
All of the following Free/Libre software packages are available for
GNU/Linux, Windows, and Apple OS X. However, we highly recommend
using these programs on GNU/Linux.
The required software can be found in the Support/Downloads section
at LulzBot.com/support/downloads. You will also nd instructions there
for installing each program onto your PC. You can also nd downloads
specic to the LulzBot TAZ 3D printer on the LulzBot TAZ product page.
1.3 Installing Drivers
Linux and Mac OSX users will not need to install a driver to communicate
with the LulzBot TAZ 3D printer. Windows users will need to install
the drivers. Using Cura as your printer host and slicing software is
recommended, as the drivers will automatically be installed during the
Cura installation process. The drivers can also be downloaded from
LulzBot.com/support/downloads. A visual guide showing the driver
installation process can be found in our download section as well.
1.4 Cura
Setup Cura
Cura is available for download on our website at
http://LulzBot.com/cura. When installing, it is recommended to
uninstall any previous versions of Cura you may have been using. When
rst opening Cura, you will be prompted to go through the First run
wizard. This will consist of selecting your printer, hot end type, extruder
type, and nally your nozzle diameter.
It is important to select the correct printer, hot end, tool head, and
nozzle diameter as Cura uses custom proles and machine settings based
15