LulzBot TAZ 5 - Page 16

3D Printer Software
upon which printer, hot end, tool head, and nozzle you have.
• Download the appropriate installer for your computer operating
system. Instructions on installation for each operating system are
available at http://LulzBot.com/cura.
• Install Cura by double clicking on the installer.
• Click through the install wizard until it completes.
• Start Cura by launching it from your list of installed applications.
If this is the rst time that Cura has been used the “Conguration
Wizard” window will open.
• Select LulzBot
®
TAZ 4 or 5, then select Next.
• Select Stock TAZ 5 (PEI and V2). Press Next.
• Choose the correct nozzle size for your machine. Your TAZ 5 comes
with a 0.5mm nozzle standard.
• Select nish.
16