LulzBot TAZ 5 - Start and End Gcode Settings; View of Plugins

1.13. START AND END GCODE SETTINGS
Figure 1.17: View of Plugins
Tweak at Z
Make basic changes at specied Z heights. You can dene the Z height or
layer count at which you want to make a change. Then choose how you
would like to change your settings. You can alter temperatures, fan speeds,
and print speeds. Fine tuning these for specic STL les, can produce
cleaner prints.
Pause at Z Height
Pause your print at a specied height. You can also specify where to
move the print head and how much lament to retract. This will prevent
“blobs” from accumulating on your print while paused. This setting is most
commonly used when switching colors of laments in the middle of a print.
1.13 Start and End Gcode Settings
Custom Gcode allows for complex automatic printer movements and op-
erations. By adding custom Gcode into the start or end of your le, you
can alter how it prints. A comprehensive list of Gcode commands can be
found here: http://reprap.org/wiki/G-code We recommend new users
37