LulzBot TAZ 5 - Infill Pattern Settings; Infill Pattern: Line (344.51 Mm; 5 M:20 S); Infill Pattern: Rectilinear (350.57 Mm; 5 M:23 S)

Slic3r
Infill Patterns and Density
There are several considerations when choosing an inll pattern: object
strength, time and material, personal preference. It can be inferred that a
more complex pattern will require more moves, and hence take more time
and material.
Figure 2.22: Inll pattern settings.
Slic3r oers several inll patterns, four regular, and three more exotic
avours. The numbers given in brackets below each gure are a rough
estimate of material used and time taken for a simple 20mm cube model
15
.
Note that this is only indicative, as model complexity and other factors
will aect time and material.
Figure 2.23: Inll pattern: Line (344.51mm / 5m:20s)
Figure 2.24: Inll pattern: Rectilinear (350.57mm / 5m:23s)
15
Taken from http://gcode.ws
92