2.5. EXPERT MODE
• First layer speed - As mentioned in subsection 2.3, the rst layer is
important to lay down correctly, and a slower pace helps enormously.
Setting a value of 50%, or even less, can really help.
Acceleration control is an advanced setting allowing acceleration
settings for perimeters, inll, bridge, as well as a default setting, to be
made. Deciding which values to set depends on the capabilities of the
machine. Any settings within the rmware may be a good starting point.
Take into account any restrictions enforced by the rmware as many
have settings for the maximum safe speed of each axis.
91
To Next Page
Loading...
