LulzBot TAZ 5 - Cool; Start Distance; Minimal Length

3D Printer Software
Start Distance
This will dene the distance away from your model that the skirt will be
created.
Minimal Length
This will dene the minimum extruded line length for the skirt. This will
over ride your line count, producing as many lines as required to reach the
minimal length.
1.17 Cool
This section will dene how your extruder cooling fan will operate during
the print. Your fan will not start until it has reached 25% or higher for
speed settings. If your print speeds are slowed down due to minimal layer
time, the fan will run between minimum and maximum speed based upon
how much the layer is slowed down.
Fan on at Full Height
This is your Z height where your fan will be turned on to its minimum
percentage setting. Especially helpful with high temperature retaining
laments such as PLA. This will be scaled between 0%, and your minimum
fan speed based upon layer height; with it being disabled for the rst layer.
Fan Speed Min
This will be the speed your fan runs when enabled at full height. Once the
Z height is reached for Fan on at Full Height, this will be the speed your
fan runs at.
Fan Speed Max
This is the fastest speed at which your fan will ever run. When your print
speed is slowed down due to minimal layer time, your fan will run between
minimum and maximum speed. The maximum fan speed is reached when
your printer must be slowed by 50% or greater.
40